July 28, 2023
If there are problems during operation of the Powder Milling Machine, press the emergency stop (all the parts of the machine will be stopped).
| Faults | Reason | Shooting |
| The motor doesn’t work | 1. fuse breaks off 2. contactor doesn’t contact well 3. the circuit is not through | 1. change the fuse 2. check or change it 3. check or change the wiring |
| Noise | 1. bearing is attrited 2. unbalance of main shaft, movable hammer, fan device | 1. change the bearing 2. do the balance test |
| Low capacity, uneven powder | 1. movable hammer or liner is attrited 2. tube jam; powder stick on the impeller of the air-lock device 3. filer pockets are broken 4. air leak of the tube 5. sieve is broken or has the jam | 1. change them 2. clean the tube and the air-lock device 3. adjust or change it 4. seal it 5. clean or change it |
The above is the Trouble Shooting of Powder Milling Machine we have listed for you. You can submit the following form to obtain more industry information we provide for you.
You can visit our website or contact us, and we will provide the latest consultation and solutions
Send Inquiry
Most Popular
lastest New
Related Products
Send Inquiry
Send Inquiry
Ms. Susan
Tel:86-0510-86184255
Fax:
Mobile Phone:+8615961650796
Email:susanliu35@gmail.com
Address:No.8 Dongmeng Road, Dongmeng Technology Zone, Nanzha Town, Jiangyin , Wuxi, Jiangsu
Related Products List
Mobile Site
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
